Search results

Hey trep i bought one from bass pro parts department. It was a quicksilver line with bulb. The one i had had 2 ends on it. I cut them off and used 2 ss screw clamps. Make sure u get a mercury / quicksilver line and bulb. And make sure its the new ethonal resistant stuff

According to my manual a 96/97 75 elpto gets 1-1/8 for all three

What year is your motor? Is it a elpto or what

Exactly fatrap. When i get off work im gonna go find mine. Its sad that usually we dont do things until something bad happens then we say damn why didnt i research that already

I dont know but u should be able to pull yours off and measure the shaft

Hey fat rap glad to see that u got it. I was fishing one night here on douglas lake and i was running down the lake. I noticed lightning in the back ground so i decided to fish one more spot. After i did i planed back out and trimmed way up. I slowed down and trimmed down because of wake from...

Thanks man

It could but have your tried messing with the trim tab

Hey i dont know about the 150 but make sure everything lines up including the driveshaft. I spin my prop by hand when im pushing her in

Its clear and no its easy once its still wet. But its really good stuff. Bass pro does sell it so i went there cause its close.they sell it online everywhere too i think even amazon too.

Hey on the silicone i used life seal from bass pro. Its what bob b suggested for the transom bolts. Its really good stuff also when i did mine i found out what the torque needed to be so i torqued them down

Hey i pit bocca bearings in my curados and citicas and love them

Hey what i do is i have 2 vises one for tying then the other i put non skid tape on the vise and i put the top half rubber in tighten up pull real hard then take scissors then cut along the vise. Then i do bottom half

Hey ron bob is right. Last year i went through the same thing. Mine was in second hole from top. Horrible hole shot.i moved it down one to middle hole. Huge difference with that one hole. Mine has the 125 elpto.

Thank you bob

Ok bob do you have the part # ? Is it 21-857005A1. Thank you brother

Ok bob thats what im asking which in the pulse pump? Is that just the fuel pump? And what filters. Thanks bob

Bob whenever i changed the filter there was rubber pieces from the lines in it. So anyhelp bro im sure its went into the pump and stuff i just am not familiar with the parts thanks bob your the man

Ok bob the pulse pump is fuel pump correct? If so rebuild kit or buy one. The bleed line check valve where is that and do you have any part numbers? To clean all 4 carbs is this something simple to do? Thanks bob also model is 1125412WN

Ok i was just thought this was a easier way of letting you know thanks bob