Jeffry Skidmore
Well-Known Member
- Joined
- May 18, 2011
- Messages
- 356
- Reaction score
- 1
Should the butt of the transducer be kicked up a little when fine tuning the installation. I'm somewhat OCD about detail, comes from my career. My thinking is that, with two bodies, gas and gear in the boat idling along scanning, the back of the boat is angled down. If the 'ducer is mounted square, then the beam is not shooting "parallel" to the bottom. Is this a reasonable theory, and if so, will the performance of the transducer be affected?
Thanks!
Thanks!