i have a 2005 nitro 188 sport with a 115hp mercury 2 stroke. i have 3 motor trim locations on my boat: 1 on the bow; 1 on the throttle; and 1 on the motor itself. both the bow and the throttle work fine, in both directions, but the, motor trim, stopped trimming up only...it still trims...
Good afternoon, I am brand new to this forum but at a loss as to what to do. I bought my dream boat back in Nov of 2018 (Nitro Z21 2018). It was stolen in the spring of 2019 and when it was found two days later it was stripped. I have had all the components replaced but have a problem with...
Just to advise. I've recently found a couple of concerning issues with my Z18. These are relevant to the rear port side. First, I noticed a gasoline odor when raising the rear compartment cover. Upon further inspection I found the fuel line (5/8 suction line) clamp loose and stripped...
'96 17' Nitro 170TF Rick Clunn Edition
75hp Tracker Motor
New trailer 2017
Engine tune up last year
New throttle control and cables
Buy today, put it in the water tomorrow
Location: Pleasanton, CA
1993 Nitro 190TF 19’ bass boat with cover $4,000
Johnson 150hp motor
Humminbird depth finder 798ci HD w/ internal GPS
Humminbird depth finder 898c -GPS
MotorGuide 24-volt trolling motor w/ 82 lbs. thrust
front foot pedal for trolling motor
stainless steel prop
motor runs great...
I'm getting ready to start my 3rd fishing season with my Nitro 700lx, and I'm still struggling on prop and engine setup. The boat came with a 23P aluminum prop. I was able to get 44-45mph with gps. After talking back and forth with my local boat shop, I ended up buying a 21P Solas Saturn SS...
I just bought this boat a little over a month ago and have taken it out 4 times or so.
Its not my first boat.. so I'm experienced with getting boats on plane.. but damn this boat is a tuff one!
this is 20' 2" and paired with the Mercury 225 Dfi (3.0l)..
Currently I'm replacing spark plugs...