Gary Weaver
Member
- Joined
- Nov 15, 2002
- Messages
- 22
- Reaction score
- 0
I use this procedure is it correct????
1. pump the fuel line bulb until it fills with gas
2. set the throttle control to fast idle about half way
3. push in the key to choke and then turn key
the motor will start and run a few seconds then it will quit. I have noticed that just before it quits you can press the key in again for a second and it runs a little longer. is this bad? am i doing something incorrectly?
i would like to just have to crank the motor once and keep it running - less wear and tear on the parts?
Thanks
1. pump the fuel line bulb until it fills with gas
2. set the throttle control to fast idle about half way
3. push in the key to choke and then turn key
the motor will start and run a few seconds then it will quit. I have noticed that just before it quits you can press the key in again for a second and it runs a little longer. is this bad? am i doing something incorrectly?
i would like to just have to crank the motor once and keep it running - less wear and tear on the parts?
Thanks