installing depth finders

[ron buffington]

has anyone put a fish finder upfront? how hard is it to pull the wires? I am going to put the trasducer upfront but I have to get the power cables to the back. I have a pro team 165

 

[Mike Tosello]

Ron

First check to see if there are leads in any type of harnass that runs up to the front of the boat already, sometimes thr factory wiring has power leads already in place up there to make it easier for the dealers to install the units.

See ya on the water, Mike
http://

 

[Mike L.]

Ron .go to 'Grab Bag' on this site....see is the one titled...Bow Mounted Eagle helps you!!!!...Mike L.

 

[Mike L.]

GrabBag is under the 'Resources' Category!!

 

[Russ Charles]

Run #16 on a seperate circuit from the fuse panel for each depthfinder. Use a wire snake to pull the wires.



Russ

 

[Sam Elkins]

Also check under the front panel where the tilt switch is. Some are already pre-wired and the wires are even labeled.