bleeding brakes on a trailstar tandem axle trailer 2019 Nitro z20

Nitro Owners Forum

Help Support Nitro Owners Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Donald Watson

Active Member
Joined
Sep 23, 2004
Messages
44
Reaction score
5
Location
Bonita Springs, Fl
We know how to bleed the brakes but can only find a bleeder on the right rear wheel nothing the on the other side. Is there only one bleeder for the entire system.?????
 
Performed complete brake job the boat trailer and there is only one bleeder. It is on the right hand side and the location where the bleeder would be on the other side is just a plug. So bleeding the the one side bleeds the whole system. Go figure.
 
Yes there is only one.
Did you prime the master cylinder first by doing short 1/2 inch strokes on the plunger/coupler? Remove the cover, don't look down inside at a close range. prime the master until liquid shoots straight up. Once done then bleed the brakes through that one bleeder.
 
Yes we did prime the master cylinder and yes it did squirt. Then did the bleeding procedure although it took quite a few strokes this accomplished everything fine now. Installed the Tie Down brake pads. Took for test ride all 10-4. Thx for input.
 

Latest posts

Back
Top