trolling motor

Nitro Owners Forum

Help Support Nitro Owners Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. ClubMonki

    Is a 80lb troller too big?

    I just got a nitro 160 and need a powerful troller for wind and current. Is a 80lb too much? Should I just mount to the bow with screws or add a wood mount under the bow? Suggestions are helful. I have never done this.
  2. K

    Boat For Sale 2018 Tracker Pro195TXW with Mercury Marine 150L ProXS Optimax 150 HP outboard. $22,000

    2018 Tracker Pro195TXW with Mercury Marine 150L ProXS Optimax 150 HP outboard and Trailstar TXXPT195P trailer, Minn Kota Edge Bow Mount trolling motor with remote (foot control). Boat Serial # BUJ47445G718 Engine serial # 2B527637 Trailer Serial # 4TM11HJ11JB001248 Boat purchased in November...
  3. Jimmopotumus

    Trolling motor mounts

    This May have been covered before but I would love some new insight. I have a Nitro Savage 20’ and just put a large 36v Fortrex trolling motor on it because the old 55 lb motor was way too slow. The boat is a heavier version than the newer models and the problem I am having is the rubber motor...
  4. R

    Nitro 188 Sport Trolling Motor Shaft Length

    New member here and I recently picked up a 2002 Nitro 188 Sport that did not come with the trolling motor. Any other 188 Sport owners out there that could tell me what’s the TM shaft length? I have been trying to find an answer online but can’t, and the boat is currently being serviced. So, I...
  5. G

    Greetings From Ramona, Ca. Nitro Service In Southern California?

    2008 Nitro 189 Sport. Can anyone suggest a GOOD marine electronics installer in Southern Ca? I bought a new Humminbird Helix 10 and Minn Kota Ultrex motor that needs to be installed. Have contacted the BASS Pro/Tracker store and service center in Rancho Cucamonga but not sure they sound competent.
  6. G

    1994 Nitro 160tf Recessed Foot Control

    I'm wanting to install a Minn Kota Ultrex as well as a recessed foot control compartment. Does anyone know what kind of bracing and/or location of bracing for the bow deck? Just want to get an idea if it's doable before cutting a hole in it.