Search results

I agree with Nativejim.. except I bought a heaver outdoor carpet from home depot . I did mine right in the marina and left my boat in water for a few hours. Its best to have 1 person with you to help hold the rugs and help screw in the boards. it will go faster... I also brought my compressor...

I saw one video on you tube . The trailer was a newer style and they pulled the assembly thru the back. The problem I see on my Tongue is the sway away pin bushing looks like it my be tack welded in. The other issues is pulling the break line off the solenoid I can not get to the fitting to...

Hi I need to replace my breakaway cable. The cable rusted and broke off . Can anyone guide me thru the process . How do I pull the assembly out to get to the cable assembly .. Its a 2001 Nitro trailer and it seems like the swing a way pin has a bushing welded? in the tongue and it is the...

Hi Guys can any one help me. I haver a 2001 Nitro trailer with Trailer buddy disk breaks and UFP disks.. Can any one tell me the size I need. I can not see the number on the breaks to track down the size of disk and pads... the trailer number is 4TM15CH162B001034.. any info would help... Pete

Thanks Vic. I will look for a service manual. I will not tackle the oil pump if it seems complicated. Engines are expensive.. Pete

Can any help me out? I have a question. My oil reservoir is leaking out oil into my carbs. is there a check valve or is the oil pump bad? It seems like it leaking into my carburetors and making it hard to start. If I let the boat sit awhile it drips out till the low oil alarm goes off...

Thanks Toxic I will check it and let you know how I make out

Thanks I will

CAll Bass pro they had one for my 288 sport. it was in stock too

Just to let anyone know. instead of getting a new ladder handle for my nitro 288. I had the handle tig welded. This worked very well.I did not want to buy a new one because of the poor design. The weld is holding better than the Factory weld. The weld on the factory model was just a spot weld...

After further research. The handle is call aft handle . The OEM handle is made pretty poorly. It has a bolt tack welded to the tube. The weld broke . I am going to a weld shop to see if it can be re-welded. The new Handle only cost 69 bucks . If its made the same way I would hate to spend the...