Looking for someone to fabricate a switch plate for a 2002 Tracker Pro Team 165

[Steve Bag O Donuts]

Hello. Im looking to have someone fabricate a new switch plate for my Tracker proteam 165. Please send quotes via this thread or PM me.

Thank you!

 

[Andrebass]

Are you willing to sand and repaint? A couple hours of sanding and prepping would make the plate brand new again and cheaper. Maybe take it to a body shop to paint it or have it dipped in chrome.

I just now read where you state that it is plastic. a piece of metal would be thinner, since you said it has to be flexible.

 

[92 Nitro 190dc Owner]

I made new ones for me from black starboard.

 

[Steve Bag O Donuts]

I made new ones for me from black starboard.

Did you use a dremel to cut the holes for the switches?

 

[92 Nitro 190dc Owner]

Yes and made templates that I could clamp down that would keep me inside the lines. The templates were made from thin scrap and took a bit of fine tuning to get each template to just the right dimensions for the square holes. Actually much easier than I thought. For the round holes, a hole saw or drill bit was used.

 

[Scvhuskers]

I have a CNC mill in my shop and I love doing this kind of stuff. I can make new ones from aluminum and I don’t think it would cost much. Basically enough to cover material

 

[Scvhuskers]

Here is a pic of a pair of handles for the back of a Lowe Jon boat I made for a guy. The original and two new ones

 

[Ltwrangler]

Nice job on the handles

 

[OldDude]

Nice work