Search results

Nitro Owners Forum

Help Support Nitro Owners Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. B

    Exhaust leak

    Have a 2005 nitro nx750.90 mercury.had lower unit oil changed.and new water pump replaced.went to lake.pulled out .wiping boat notice lower unit was discovered between lower unit and upper unit.on lower unit see where exhaust burn of off paint.tiok to repair shop.they dropped lower unit.put it...
  2. B

    Water

    2095 nitro nx 750.had water pump and gear oil serviced at local shop. Got bk home put boat on ear muffs. After changing plugs. Had water coming out where the shift shaft goes into lower unit. Never noticed that before .is this normal. Or did the shop forget something. Water gauge at idle 7 .
  3. B

    Gauges acting up

    I replaced voltage regulator.evrything works.tach.voltage gauge.and miss is gone.
  4. B

    Wires burnt

    Have a 2005 nitro nx 750 .with 90h.p mercury.wires in voltage regulator rectifier.are burnt.where I bought boat.they had spliced wires before.said regulator was gd.but wires have burnt melted where they spliced again.help.is it the regulator or stator or trigger causing this.tach jumps . voltage...
  5. B

    Gauges acting up

    It's a 2005 nitro nx750 with 90 mercury
  6. B

    Gauges acting up

    First tach.started acting up.now trim and battery acting up.i can knock on gauges then they read right for except tach.any help.thks
  7. B

    Prop

    Ran through mud an rocks.scracth lower unit.but prop had gotten bit dinged up.prop repair shop cleaned the edges up where they was damage.but now my techometer will not go over 5400 rpm.at wot.before it would hit 6000 rpm wot.which 19 pitch .2005 Mercury 90 h.p.i don't run it over 5500 rpm.by...
  8. B

    Carburetors Leak

    What is the correct height setting for the floats.2005 Mercury Marnier 90 h.p.carburated.thks
  9. B

    Carburetors Leak

    2005 nitro nx 750.90mercury.carbs leak when motor is trimmed up.mechcanuc says that's normal.had them rebuilt Had carburetors rebuilt.2005 nitro.90 mercury.mecanic said they will leak when motor is trimmed.
  10. B

    Cables

    Do u turn the trim tab toward the way it pulls.or the opposite way it is pulling. Thks
  11. B

    Prop

    Question on boat.first start it up idles 2000to2400rpms.takes forever to idke down or when put it in gear.run bout 20 mins. Up lake pull up on bank to fish it just dies.startsback up but idle is up and down.short runs doesn't do it.the shop spilced wires on the voltage regulator.there where...
  12. B

    Prop

    Place where I bought my boat put a new lower unit on it and put a solas 19 pitch.rpms went from 5500 wot to 5800 wot with 19 pitch.feels like it's slower out the hole.guy said he put the 19 on because it was slow out the hole.the 21 pitch had a bent blade.all new to me
  13. B

    Prop

    Place where I bought my boat put a new lower unit on it and put a solas 19 pitch.rpms went from 5500 wot to 5800 wot with 19 pitch.feels like it's slower out the hole.guy said he put the 19 on because it was slow out the hole.the 21 pitch had a bent blade.all new to me
  14. B

    Prop

    K. Thks.place where I bought the boat put a new lower unit and a 19 pitch aluminum prop.still had a problem with idle.when I run bout 20 or 25 minutes at work.come up to the bank to fish slow down it just dies.like u turn the key off.start it up idles real rough round 9500 ROMs then it starts...
  15. B

    Need Help With Hard Shifting/throttle

    I have 2005 nitro nx750.had problems with stiff hard shift.take cable off to throttle.crap the the lingage going to shift rod.if it's still stiff.most likely it's the clucth and dog in the lower unit.i bought new lower unit problem is gone.
  16. B

    Prop

    I have a 2005 nitro nx750.17half long.with 90mercury track carburator.has a 21 pitch allumin.woukd I loose rpme and hole shot it I put a 22 picth stainless Mercury laser 2 .my aluminum 1 has a blade bent.i like a better hole shot and more speed.it runs 46 at 5400 rpms now.thks for any help
  17. B

    Steering Problems

    Have 2005 nitro nx750.steering has play at the steering wheel bout 3 quarter play do I have to replace the box that connects to the cable if so anyone know what part number.its 17 half ft boat sc model.thks
  18. B

    Shifter

    Figured out it's not my throttle cables sticking binding.took them off cables move freely.reached started moving the slider where cable hooks to.had to force it to go in recerse.now I'm stuck is it in the lower unit sticking or is it the arm going into a bind.i need a web site for helm on my...
  19. B

    Cables

    Couple of ?first my steering has boutinch play before it's turning either way.while going down lake steering wheel is turn left half way to go straight.have to hold it there cause it wants to pull hard right.let go of steering pulls hard right.now ?2. On the lower mount area .is that area so...
Back
Top