Search results

Nitro Owners Forum

Help Support Nitro Owners Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. R

    Need Prop suggestions for Tracker Tournament 18V

    Larry, did u ever get a prop size that gives u the performance you like? If so what was it.
  2. R

    Info on the Minn Kota terrova

    I am about to purchase a Terrova TM. Anyone have one on a Tournament V-18? I would like to know the Shaft length your are using. I think a 45 inch would work. Any suggestions ?
  3. R

    Changing to 24 volt system

    Air Force thanks for the feed back. I will run my wires on the oppsite side. Just confirming how others wires were run. It will be a little extra work but if it stops interference it will have to be done. I am changing from 8 to 6 gauge wire. Are u running a 24v system and do u know what...
  4. R

    Changing to 24 volt system

    Ok. I do alot of spider rig fishing so I'm upgrading my 12 volt trolling motor system to a 24 volt Minn Kota Terrova. I will be changing out my 8 guage wire with 6 gauge. I have read that it is advisable to run your trolling motor wire on the opposite side of boat of your electronics wires...
  5. R

    Need Prop suggestions for Tracker Tournament 18V

    I have the same set up. I run the 90 hp for several years then went with a 115 optimax. With the 90 I run a 19 pitch blackmax prop it would turn 5400 rpm and performed well it run about 43 mph per gps. The prop did have a problem of blowing out on sharp turns. I run a 19 pitch 4 blade...
  6. R

    Jumping Battery

    Thanks for the info. I do have a built in transducer. How would jumping off that battery effect the transducer?
  7. R

    Jumping Battery

    I ran my cranking battery down and needed to jump off my trolling motor batteries. The trolling motor is 24 volt. I was not sure how to jump off these batteries . My question is how do you jump a 12 volt battery off a 24 volt system without disconnecting a bunch of cables?
  8. R

    115 OPTIMAX OIL DIPSTICK

    Thanks. But the dang thing is all plastic and you can't see it thru the tank. I guess leaving it in there is the best option.
  9. R

    Motor height

    My prop is a black maxs 13X19 three blade. It does well and tops out about 5400 rpm. I do have a problem on turns with the prop breaking loose and over reving unless I trim down prior to turning. I am going to try a 4 blade Spitfire prop this weekend it should prevent the problem on the turns...
  10. R

    Motor height

    I have a 08 V18 with a 115 optimax also. My motor is mounted on the second hole from the top. What is your top speed and size of your prop. I have a 19 pitch and get about 44 mph. Thanks
  11. R

    Opinion and info on Tournament V-18 help

    If you do get the V18 with the 90 putting a jack plate on it is not worth the cost for a extra mile an hour. The boat will run fully loaded with gear 39/40 mph. The pro team 18 I had had a few leaking rivets also. Good fishing.
  12. R

    Opinion and info on Tournament V-18 help

    I have a few answers to your questions. I have a 09 tourney v18. Love it. Plenty of storage space. With the deep V design it handles rough water as well as any glass boat. I spend a lot of time on Ky lake and it gets rough. With the 90 you can get 40 mph with the 115 you can get 43 to 45. I...
Back
Top