Search results

Nitro Owners Forum

Help Support Nitro Owners Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. D

    Installed Humminbird target lock mega live on my bass boat foot pedal problem.

    Have done that many times. To no avail. Going to call humminbird again!!
  2. D

    Installed Humminbird target lock mega live on my bass boat foot pedal problem.

    Replaced them already and it made no difference. TY for responding.
  3. D

    Installed Humminbird target lock mega live on my bass boat foot pedal problem.

    Installed TL Hummindbird Mega Live on my Z20 nitro. The steering mechanism works fine with the left and right cursor keys on the HELIX 10. When I pair the foot pedal to the HELIX 10 it says it is paired but it will not steer the transducer. Any tips or suggestions would be appreciated. The...
  4. D

    bleeding brakes on a trailstar tandem axle trailer 2019 Nitro z20

    Yes we did prime the master cylinder and yes it did squirt. Then did the bleeding procedure although it took quite a few strokes this accomplished everything fine now. Installed the Tie Down brake pads. Took for test ride all 10-4. Thx for input.
  5. D

    bleeding brakes on a trailstar tandem axle trailer 2019 Nitro z20

    Performed complete brake job the boat trailer and there is only one bleeder. It is on the right hand side and the location where the bleeder would be on the other side is just a plug. So bleeding the the one side bleeds the whole system. Go figure.
  6. D

    bleeding brakes on a trailstar tandem axle trailer 2019 Nitro z20

    We know how to bleed the brakes but can only find a bleeder on the right rear wheel nothing the on the other side. Is there only one bleeder for the entire system.?????
  7. D

    Touch panel problem

    On the replacement panel from Spyder Controls it came with a metal plate behind the circuit panel. The one I took off the boat did not have a metal panel behind it. We did not overtightened in any event. Thx for the tip.
  8. D

    Touch panel problem

    Final result was the replacement of the touch switch panel. All functions are working again. Purchased the new panel from Spyder Controls for $150. shipped overnight. We believe that when the power button connection was loose and intermittent it toasted something in the circuit board on the...
  9. D

    Touch panel problem

    Will Do.
  10. D

    Nitro 640LX struggling to get on plane. Help!!!

    I had a similar problem with a 929cdx 225hp opti and our solution was removing the plugs on the prop as I recall we tried 3 different size plugs and ended up leaving out one or two plugs which allowed the motor to rev quicker and improve the hole shot.
  11. D

    Touch panel problem

    Checked every circuit and every fuse, relay, ground and power feed. Trace 12 volt power directly to the plug feeding the touch switch panel. Conclusion the only thing we can determine is that the switch pad is messed up. Ordered new one from Spyder Controls $150. and pray that this solves the...
  12. D

    Touch panel problem

    2019 Z20 Pro. touch panel wont light up and also dash lights out as well. power switch had a loose wire but tightened and it lights up fine. All electronics work as well as talons ,tilt trim, and jack plate and trolling motor and radio lumbar switch fan switch works. While on the water the...
  13. D

    replacement fenders

    Does anyone know if the attachment points on the steel fenders for a tandem z20 2019 trailer are the same as the fiberglass attachment points. Damaged both fenders and may replace with steel. Probably cheaper than haviing them repaired.
  14. D

    Does anyone know how to access the seat pedestal mount on the bow on 2019 Nitro Z20 Pro.

    Removed the fan in the main compartment and it accessed the pedestal mounting hardware. picked up replacement pedestal at bass pro. The weld on the pedestal had broken. Six screws and nuts and done. Just make sure to get the correct bolt pattern on the replacement.
  15. D

    Does anyone know how to access the seat pedestal mount on the bow on 2019 Nitro Z20 Pro.

    Disregard I removed the fan in the center compartment and it allowed access to the pedestal mount.
  16. D

    Does anyone know how to access the seat pedestal mount on the bow on 2019 Nitro Z20 Pro.

    My front pedestal mount is loose or bent. When the seat pin is in the hole it sways all over and feels like it broken underneath the deck. Not sure how to access it. I have the optional fan mounted in the front of center compartment right under the light. I thought removing the fan may...
  17. D

    lower step on nitro Z20 pro trailer.

    Getting older and cannot step up onto tongue of trailer. Added a step part way in between. Helps a great deal thought I would share.
Back
Top